
agri-updates
2000/1

2000/1
ESTABLISHMENT
OF KIKUYU
John Cunningham & Peter Bartholomew
Introduction
Kikuyu is a highly nutritious summer growing creeping
perennial grass that is adapted to a wide range of soil and climatic conditions.
Best production is obtained when grown in areas receiving more than 700 mm of
rainfall. Although suited to most soils it is not advisable to grow kikuyu on
soils subjected to waterlogging, on heavy bottomland soils nor on sandy or very
shallow soils (there are other species better suited to these situations).
There are many advantages to planting kikuyu for animal feed.
These include inter alia, easy to establish, can be planted on steep and
/ or rocky slopes, can be established without the need for machinery or special
equipment, can withstand severe defoliation, is frost resistant, provides for
good animal performance, provides for reasonable foggage (standing hay), can be
used for silage and hay, can be oversown with temperate grasses (e.g. annual
ryegrass) and fodder radish for winter feed, is reasonably drought tolerant,
can withstand' being burnt, planting material is usually close at hand, an
excellent soil erosion control species and promotes water harvest.
Although the best production and animal performance will be
obtained from rotational grazing, kikuyu can be continuously grazed.
Establishment
Kikuyu can be established using either vegetative material
(runners: stolons and 1 or rhizomes) or seed. Establishing a kikuyu pasture from
seed is slower than establishing with vegetative material.
Seeded cultivars are not generally recommended. Use of seeded
cultivars can result in kikuyu being spread into arable lands by animals. When
seed is used conventional pasture establishment techniques are recommended.
Special care must be taken to control weeds as the kikuyu seedlings are
sensitive to competition from weeds. Also, in areas which experience frost,
seeding should take place at least eight to ten weeks before the first expected
frost.
Vegetative establishment
There are several methods that can be used to establish kikuyu
vegetatively. The actual method used will depend on the resources available
(implements, labour, funds), the terrain (steep, stony, arable) and on the
availability of planting material.
Vegetative establishment can commence once the spring rains
have started. Planting should always be into moist soil. With the exception of
spot planting (where no seedbed preparation is required), planting should be
into a previously prepared area (fertilised, ploughed and disced).
Spot planting
Kikuyu can be spot planted in areas that are too steep or stony for
machinery to be used. Spot planting can also be used on arable areas where
machinery is not available. The following procedure has proved successful:
-
Clear the over-burden (excess grass, old crops etc) by
burning, heavy grazing or spraying with a herbicide, followed by burning.
- Two (2) teaspoons of a phosphorous fertiliser are spread on the bottom of
the indentation and, preferably, covered with a thin layer of soil by
'kicking' soil into the indentation.

Spot planting
kikuyu. The 20 x 20 cm indentation
- A 20cm square divot (sod) of kikuyu is then placed in the indentation.
Planting material: It is important that the divot that
is placed in the indentation is a compact sod and does not consist of loose
runners (stolons and rhizomes)
Disc
An off-set disc can be used to remove the kikuyu planting
material as well as to incorporate the material into the soil.
The disc should be set to 'cut' to a depth of 10 to 15 cm.
After discing sods 'out' the sods are picked up and spread evenly over the
land to be planted. This area is then lightly disced (10 to115cm deep),
preferably twice, before rolling.
Plough
A single, 2 furrow or 3 furrow mouldboard plough can be used to
draw furrows to accommodate the planting material (roots and runners). A row
width of 90cm is recommended. If a 3 furrow mouldboard plough is used then the
middle mouldboard is removed. The furrow should be about 10 to 15cm deep.
Planting material (roots and runners) is then place in the row with about 5cm
of leaf above the ground level. Roll, preferably with the tractor wheel, as
soon as possible after planting.

The divot to be
planted must be compact and not loose runners
Rotovator (rotary plough)
Kikuyu can be
lifted and incorporated with a rotovator. The proven method is to lift the
rear flap of the rotovator when 'lifting' the planting material, and to close
the rear flap when 'incorporating' the runners (i.e. after the lifted runners
have been spread over the land to be planted). Tractor speed is important for
lifting and incorporating runners. The tractor speed should be at
walking pace (PTO speed 450rpm). For both lifting and incorporating
runners the rotovator should be set to a depth of 6 to 10 cm: this depth
is crucial to success.

The planted divot before covering with soil
and compacting by foot
Excess leaf should be removed (by grazing or mowing)
before lifting the runners. Rolling, following incorporation of the runners,
is of cardinal importance. Roll at least twice with a cambridge roller.
Planting material
Seventy five 50kg fertiliser bags of roots per hectare are required
for the disc, plough and rotovator methods of establishment. One hectare of
kikuyu will plant about five hectares of new pasture. It is advisable to graze
or mow the kikuyu before lifting the planting material.
Irrigation
If irrigation is available this should be applied immediately after
planting and rolling to facilitate establishment.
Utilisation following planting
Irrespective of whether the spot planting, disc, mouldboard plough
or rotovator method of establishment is used it is important to graze the new
pasture as soon as the roots cannot be pulled out by the grazing animal.
Grazing encourages lateral spreading of kikuyu. The application of fertilisers,
particularly nitrogen, should commence once growth becomes evident in the
newly planted grass. When kikuyu is spot planted into the veld it is advisable
to apply additional phosphorous containing fertiliser around the spreading
divot to encourage stolon and root growth away from the parent plant.
______________________________
Further Information
Dr P Bartholomew
Telephone: (033) 355924 7
or Mr
John Cunningham
Telephone: (033) 3559250
[ PUBLICATIONS HOME ]
|